Congratulations on receiving your new pair of N2! Use this guide to learn about pairing N2 with your preferred device, charging the batteries, and restoring the earphones to their factory settings.
What's included in the box
- N2 wireless earphones and charging case
- Type-C USB-cable
- Owners manual
- Warnings Manual
Before getting started
The earbuds will likely have some existing battery charge, however it is recommended to fully charge N2 before using it for the first time.
Turning N2 on or off
N2 powers up as soon as the lid on the charging case is opened, as indicated by the LED lights on the earbuds and the audio feedback 🔈 On.
Similarly, N2 is turned off when placing the earbuds back into the case.
You can also use the touch controls to power the earbuds on or off. Do this by holding the touch control for 5 seconds on either earbud until you hear the audio feedback 🔈 On or 🔈 Off.
Pairing with a device
N2 enters pairing mode when opening the lid on the charging case. Open the Bluetooth settings on your device and wait for N2 and the device to locate each other, then select Sudio N2 when it appears in the list. You will hear 🔈 Connected, confirming that the devices are paired with each other!
Charging the batteries
There are three batteries in total on N2; one in the charging case and one in each earbud.
The N2 earbuds charge their batteries automatically when placed inside the charging case, this is indicated by the LED lights on the earbuds. Make sure to first remove the protective film which is covering the charging connectors.
The N2 case is charged with a Type-C USB-cable and can also be charged wirelessly. When the case is charging, you will see a light on the front o the charging case. It is recommended to use the Sudio Type-C USB-cable that's included in the package, but the charging case may be compatible with third-party Type-C USB-cables as well.
Restoring N2 to factory settings
If N2 is behaving unexpectedly or you simply wish to restore it to its original settings, reset it by placing the earbuds inside the case and press the button on the bottom of the case for 5 seconds. The reset is complete when the LED light on the front of the case flashes white twice.
You may then proceed with pairing N2 again.